1. Open the print-cartridge door.
2. Release two tabs (callout 1) to pry the cover away at the back of the printer
approximately 38 mm (1.5 inches).
NOTE A screwdriver is required to remove the left-side cover from an HP LaserJet 1160 printer.
3. Slide the cover toward the front of the printer to clear the interlock tab
(callout 2).
4. Lift the cover away from the printer.
1. Open the print-cartridge door.
2. Lift the back of the printer off of the workspace and use a flat blade
screwdriver to pry
the cover from the tab (callout 1) at the bottom of the printer.
Figure 6-3. Removing the right-side cover (1 of 2)
3. Use a flat blade screwdriver to pry the cover at the back of the printer,
releasing two
internal tabs (callout 2).
Figure 6-4. Removing the right-side cover (2 of 2)
4. Lift the cover away from the printer.
1. Remove the left-side cover (see Left-side cover) and the right-side cover
(see Right-side
cover).
2. Remove four screws (callout 1).
Figure 6-5. Removing the back cover (1 of 2)
3. Tip the printer so that it rests on its front.
4. Release the tab (callout 2) at the back of the printer on the right side of
the printer.
5. Slide the cover toward the right side of the printer to clear the tab
(callout 3) on the
duplex tray.
Figure 6-6. Removing the back cover (2 of 2)
6. Lift the cover straight up and away from the printer.
1. Remove the left-side cover (see Left-side cover), the right-side cover (see
Right-side
cover), the back cover (see Back cover), and the duplexer tray (see Duplexer
tray).
2. Remove two screws (callout 1) at the back of the printer.
Figure 6-9. Removing the top cover (1 of 3)
3. Remove one screw (callout 3) at the left side of the printer and remove one screw (callout 4) from the front of the printer.
Figure 6-10. Removing the top cover (2 of 3)
4. Lift up the left side of the top cover and release the control-panel cable (callout 5) at the right side.
Figure 6-11. Removing the top cover (3 of 3)
5. Lift the top cover off of the printer.